PROJEX

Drawing of the electrical scheme and insertion of the devices

The electrical diagram drawing mode allows you to insert the symbols of the devices into the diagram by defining the connection mode (series, parallel, start of a new panel) or by dragging them directly into the circuit. The previously inserted device codes are selected by the program at the end of the calculation.

The devices can also be inserted directly without calculations by selecting them in according to their electrical parameters.

The electrical wiring diagram can be structured in 3 different ways.

Calculation of the parameters of the electric system

Once the drawing of the single-wire electrical diagram has been completed, it is possible to calculate the electrical parameters of the system (load and short-circuit currents; voltage drops, etc.) the results determine the components (cables; switching and protection devices, etc.) that the program selects.

The electrical parameters of the devices are automatically placed in the diagram, whose rows (data) can be set by the user. It is also possible to "block" all the devices and/or the cables or only the selected ones: the program during the verification signals any anomalies (and proposes the replacement of the blocked component with another suitable one). The photos of the devices (switches, meters, signaling, command, etc.) make the selection easier.

Board configuration (manual or automatic)

Once the devices have been defined (via calculation or direct insertion), it is possible to configure the board in automatic or manual way.

Automatic board configuration: by a single click, PROJEX selects a complete board. The board is immediately drawn and can be modified by the user; during the modifications, the enclosures is updated in real time (draw and price).

Manual board configuration: the software offers all the enclosures compatible with the devices present in the circuit and allows you to create the board in a simple way, showing (while making the board) both the shape of the devices to be inserted (highlighting those already inserted) both the structure of the scheme (highlighting also here the components already inserted). To complete the board it is possible to select busbar systems and accessories from those compatible with the enclosures used.

Finally the programme carries out the thermal test, as required by the electric board standard.

System estimation

The program allows you to obtain lists of materials (with or without price) which can be structured in various ways: general, differentiated by board, divided into the electrical part (devices) and the enclosure part (carpentry). Discounts, increases and labor can also be entered.

Printing and exporting of documentation

The project documentation (diagrams, frontviews, system/devices/enclosure data, material lists, etc.) can be exported in various formats.